5KV 1*6mm2 Airport Lighting primary cable
Standards

In compliance with FAA Specification for L-824, AC 150/5345-7E

Application

These cables are used for interconnecting the transformers and the current regulator of airfield lighting systems in series circuits,suitable for fixed applications such as taxiways, runways, touchdown zones, land and hold short lighting systems, can be installed in conduit, duct, aerial and direct burial

Construction

Conductor: Stranded bare or tinned copper.

Inner Semi-Conductor: Extruded semi-conducting compound.

Insulation: XLPE.

Outer Semi-Conductor: Semi conducting tape or extruded.

Shield: Copper or brass tape(s). Tinned copper wire braid can be offered upon request.

Sheath: PVC. PE/XLPE can be offered upon request.

Sheath colour: Black

Operating voltage:5000 V

Test voltage: 20000 VAC, according to IEC TS 62100

Partial discharge level test: 5000 V, no partial discharge

Operation temperature: – 40 °C to + 90 °C

Permissible short therm: + 250 °C

Lowest ambient temperature: – 60 °C

Bending radius: Static installation > 10 × outer .

FAA L-824 Type C Shielded 5kV
Standards
FAA AC 150 / 5345-7E
FAA L-824 Type
ICEA S-93-639 / NEMA WC74

Application
Airfield Lighting Cable are used for interconnecting the transformers and the current regulator of airfield lighting systems in series circuits,suitable for fixed applications such as taxiways, runways, touchdown zones, land and hold short lighting systems, can be installed in conduit, duct, aerial and direct burial

Construction

Conductor: Stranded bare or tinned copper.
Inner Semi-Conductor: Extruded semi-conducting compound.
Insulation: XLPE.
Outer Semi-Conductor: Semi conducting tape or extruded.
Shield: Copper or brass tape(s). Tinned copper wire braid can be offered upon request.
Sheath: PVC. PE/XLPE can be offered upon request.
Sheath colour: Black
Operating voltage:5000 V
Test voltage: 20000 VAC, according to IEC TS 62100
Partial discharge level test: 5000 V, no partial discharge

Operation temperature: – 40 °C to + 90 °C
Permissible short therm: + 250 °C
Lowest ambient temperature: – 60 °C
Bending radius: Static installation > 10 × outer .